Terminator exoskull from Thingiverse, PLA, around 8 inches tall. Took about 8 hours to print.
The lights in the eyes are on a motion sensor so they come on when someone enters the room.
Latest big print
- Spotopolis
- Posts: 79
- Joined: Tue Apr 29, 2014 9:17 pm
- Location: Colorado
Latest big print
- Attachments
-
- Term1sm.jpg
- (252.64 KiB) Downloaded 610 times
-
- Term3sm.jpg
- (247.5 KiB) Downloaded 610 times
Re: Latest big print
Not the kind of nightlight I'd prefer, but great work nonetheless!
Re: Latest big print
I know what my next project is going to be! How much support did it require?
- Spotopolis
- Posts: 79
- Joined: Tue Apr 29, 2014 9:17 pm
- Location: Colorado
Re: Latest big print
It took VERY little support - just a few columns under the jaw and a few in the temple insets. Overall it was a very easy print.
- Spotopolis
- Posts: 79
- Joined: Tue Apr 29, 2014 9:17 pm
- Location: Colorado
Re: Latest big print
Oh yeah, this was ABS, not PLA. Not sure that it matters, but I had it confused with a different print.
Re: Latest big print
sweet, amazed you were able to print something that big without it splitting on you. I tried printing a large skull once and it split and warped a lot! I am not good at finishing techniques, this would probably be a good time to start practicing!