Best of Day 2

Show off your prints!!!
Post Reply
N5QM
Posts: 11
Joined: Sun Feb 22, 2015 7:59 pm
Location: Little Rock, AR

Best of Day 2

Post by N5QM » Sat Jul 25, 2015 4:41 am

I'm on my second day with the M2 and it has been running constantly.

I have tried/tested PLA, ABS, and PETG on it now and it all works very well.

My project this evening was to print this design and light it up with a Trinket controlled Neopixel.

Here is a link for the shade, which I found on Thingiverse.

http://www.thingiverse.com/thing:29876

Here is a video of it in action..

https://www.youtube.com/watch?v=Ay5SxNRtR18
Attachments
trinket_and_neopixel.jpg
Trinket and Neopixel
trinket_and_neopixel.jpg (81.08 KiB) Viewed 2357 times
lamp_with_neopixel.jpg
Neopixel in a Shylight
lamp_with_neopixel.jpg (18.22 KiB) Viewed 2357 times
Robert
MakerGear M2 (24v) - v3b Hotend - PEI Build Surface - Astrosyn Dampers on X and Y Axis

User avatar
Jules
Posts: 3144
Joined: Wed Jan 21, 2015 1:36 am

Re: Best of Day 2

Post by Jules » Sat Jul 25, 2015 5:17 am

Kewwwwwl! :D

User avatar
jimc
Posts: 2888
Joined: Wed Apr 09, 2014 11:30 pm
Location: mullica, nj
Contact:

Re: Best of Day 2

Post by jimc » Sat Jul 25, 2015 3:03 pm

nice print. very similar concept to something i did in the past

http://www.thingiverse.com/thing:606141

User avatar
Jules
Posts: 3144
Joined: Wed Jan 21, 2015 1:36 am

Re: Best of Day 2

Post by Jules » Sat Jul 25, 2015 5:58 pm

Also Kewwwwl! :D

N5QM
Posts: 11
Joined: Sun Feb 22, 2015 7:59 pm
Location: Little Rock, AR

Re: Best of Day 2

Post by N5QM » Sat Jul 25, 2015 6:55 pm

Thank you... :-)

Jim,

It does indeed look similar. I think I am going to try your design in the "clear" PETG.
Robert
MakerGear M2 (24v) - v3b Hotend - PEI Build Surface - Astrosyn Dampers on X and Y Axis

User avatar
jimc
Posts: 2888
Joined: Wed Apr 09, 2014 11:30 pm
Location: mullica, nj
Contact:

Re: Best of Day 2

Post by jimc » Sat Jul 25, 2015 7:23 pm

yeah that one i did was in clear pet+. single wall vase mode i think.

Post Reply