I'm on my second day with the M2 and it has been running constantly.
I have tried/tested PLA, ABS, and PETG on it now and it all works very well.
My project this evening was to print this design and light it up with a Trinket controlled Neopixel.
Here is a link for the shade, which I found on Thingiverse.
http://www.thingiverse.com/thing:29876
Here is a video of it in action..
https://www.youtube.com/watch?v=Ay5SxNRtR18
Best of Day 2
Best of Day 2
- Attachments
-
- Trinket and Neopixel
- trinket_and_neopixel.jpg (81.08 KiB) Viewed 7522 times
-
- Neopixel in a Shylight
- lamp_with_neopixel.jpg (18.22 KiB) Viewed 7522 times
Robert
MakerGear M2 (24v) - v4 Hotend - PEI Build Surface
MakerGear M2 (24v) - v4 Hotend - PEI Build Surface
Re: Best of Day 2
nice print. very similar concept to something i did in the past
http://www.thingiverse.com/thing:606141
http://www.thingiverse.com/thing:606141
Re: Best of Day 2
Thank you...
Jim,
It does indeed look similar. I think I am going to try your design in the "clear" PETG.
Jim,
It does indeed look similar. I think I am going to try your design in the "clear" PETG.
Robert
MakerGear M2 (24v) - v4 Hotend - PEI Build Surface
MakerGear M2 (24v) - v4 Hotend - PEI Build Surface
Re: Best of Day 2
yeah that one i did was in clear pet+. single wall vase mode i think.