Platform Jack [Fully Assembled, No Supports]
Posted: Tue Dec 01, 2015 4:26 pm
MakerGear Forum
The Place To Discuss MakerGear 3D Printers!
http://forum.makergear.com/
Platform Jack [Fully Assembled, No Supports]
Page 1 of 1
Re: Platform Jack [Fully Assembled, No Supports]
Posted: Tue Dec 01, 2015 4:43 pm
Been wanting to print this for a while. Glad to see it works fine on the M2
Re: Platform Jack [Fully Assembled, No Supports]
Posted: Tue Dec 01, 2015 4:50 pm
0.3 Layer works fine!
Re: Platform Jack [Fully Assembled, No Supports]
Posted: Wed Dec 02, 2015 5:59 pm
I have printed this as well. Works well, but the knob for turning the screw is very breaky. I had no problems with it as long as I was careful and did not turn it while it was in a slight bind, but my daughter broke it within seconds. 
I have a "real" metal version of this jack, which is much stronger and works better, but this was just an impressively designed print. Be patient freeing it up after printing.
I have a "real" metal version of this jack, which is much stronger and works better, but this was just an impressively designed print. Be patient freeing it up after printing.