Tower of Pi
Posted: Wed Dec 02, 2015 5:18 pm
Page 1 of 1
Re: Tower of Pi
Posted: Wed Dec 02, 2015 5:45 pm
Wow. How much cleanup on that? Nice print
Re: Tower of Pi
Posted: Wed Dec 02, 2015 5:47 pm
Thank you.
I did not make a cleanup
I did not make a cleanup
Re: Tower of Pi
Posted: Wed Dec 02, 2015 5:59 pm
Very nice! I was planning on printing that myself, one of these days. It turned out much nicer than i thought it would, with no cleanup!
Re: Tower of Pi
Posted: Mon Dec 07, 2015 7:19 pm
Does it need support?
Re: Tower of Pi
Posted: Mon Dec 07, 2015 7:22 pm
Does not need support
Re: Tower of Pi
Posted: Mon Dec 07, 2015 7:29 pm
Re: Tower of Pi
Posted: Wed Dec 09, 2015 4:07 am
wow!
Re: Tower of Pi
Posted: Fri Jan 15, 2016 4:26 pm
I have printed a bunch of these for gifts.
I sand the outside, to make them smooth to the touch. Otherwise there are some roughness to the surface.
I have also printed a thin solid cylinder that I side inside the Pi container. If you put an Led Voltaire candle light inside, the sleeve lights up and the numbers are darker and more visible. Change the color of the sleeve to make the background glow different colors. The candle flickers, which is really nice. This works great with a white print and a while cylinder.
I sand the outside, to make them smooth to the touch. Otherwise there are some roughness to the surface.
I have also printed a thin solid cylinder that I side inside the Pi container. If you put an Led Voltaire candle light inside, the sleeve lights up and the numbers are darker and more visible. Change the color of the sleeve to make the background glow different colors. The candle flickers, which is really nice. This works great with a white print and a while cylinder.