This was the first thing I printed out, just the other week.
Did a light coat of white primer seen as I was having a hard time getting a nice shot with that glossy black PLA. Teeth were sculpted with Aves Apoxie
Copyrights to Marvel.
Enjoy!
Venom
Re: Venom
Very cool... nice work on the finish.
-Steve
-Steve
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com
See my projects at https://www.theneverendingprojectslist.com
-
- Posts: 3
- Joined: Thu Dec 10, 2015 4:55 pm
Re: Venom
Thanks, Steve!sthone wrote:Very cool... nice work on the finish.
-Steve
Thank you very much! Best of luck with the pendantJules wrote:Awesome! (Like the username too - I'm working on an Ouroboros dragon pendant, which i will eventually get back to one of these days.)
-
- Posts: 3
- Joined: Thu Dec 10, 2015 4:55 pm
Re: Venom
It was printed as a separate piece, but yeah, it did require a lot of support. The complete model is three piecesjsc wrote:All I can think is, "that tongue is going to need a lot of support." Unless it was a separate piece?