Page 1 of 1
Venom
Posted: Thu Dec 10, 2015 5:23 pm
by Ouroboros7
This was the first thing I printed out, just the other week.
Did a light coat of white primer seen as I was having a hard time getting a nice shot with that glossy black PLA. Teeth were sculpted with Aves Apoxie
Copyrights to Marvel.
Enjoy!
Re: Venom
Posted: Thu Dec 10, 2015 6:23 pm
by sthone
Very cool... nice work on the finish.
-Steve
Re: Venom
Posted: Thu Dec 10, 2015 6:50 pm
by Jules
Awesome! (Like the username too - I'm working on an Ouroboros dragon pendant, which i will eventually get back to one of these days.)
Re: Venom
Posted: Fri Dec 11, 2015 8:02 pm
by Ouroboros7
sthone wrote:Very cool... nice work on the finish.
-Steve
Thanks, Steve!
Jules wrote:Awesome! (Like the username too - I'm working on an Ouroboros dragon pendant, which i will eventually get back to one of these days.)
Thank you very much! Best of luck with the pendant
Re: Venom
Posted: Fri Dec 11, 2015 8:26 pm
by jsc
All I can think is, "that tongue is going to need a lot of support." Unless it was a separate piece?
Re: Venom
Posted: Sun Dec 13, 2015 8:56 pm
by Ouroboros7
jsc wrote:All I can think is, "that tongue is going to need a lot of support." Unless it was a separate piece?
It was printed as a separate piece, but yeah, it did require a lot of support. The complete model is three pieces