Buddha Sculpture
Posted: Sat Feb 13, 2016 4:10 pm
Great job as usual!
MakerGear Forum
The Place To Discuss MakerGear 3D Printers!
http://forum.makergear.com/
Buddha Sculpture
Page 1 of 1
Re: Buddha Sculpture
Posted: Sat Feb 13, 2016 4:44 pm
That's big!
Great job as usual!
Great job as usual!
Re: Buddha Sculpture
Posted: Sat Feb 13, 2016 7:43 pm
What type of filament did you use and how much of it did it take?
Really good job.
Really good job.
Re: Buddha Sculpture
Posted: Sat Feb 13, 2016 8:08 pm
Thank you! 
I used 380g of normal PLA filament.
First layer 0.2mm, other 0.1mm
2 shells
10% infil
4 bottom solid layers
5 top solid layers
outline direction was inside-out
no support
I used 380g of normal PLA filament.
First layer 0.2mm, other 0.1mm
2 shells
10% infil
4 bottom solid layers
5 top solid layers
outline direction was inside-out
no support
Re: Buddha Sculpture
Posted: Sat Feb 13, 2016 11:23 pm
No support! (she squeaked!)
How long did it take?
How long did it take?
Re: Buddha Sculpture
Posted: Sat Feb 13, 2016 11:33 pm
Took 28 hours