Page 1 of 1


Posted: Mon Feb 29, 2016 10:20 pm
by Vprints
My daughter had to make "3D models" for her science class. Naturally, she decided to go the 3D printing route. :D

We designed the volcanoes in Fusion 360, printed them -- and then she used a Creopop to fill in the lava.

(Yes, the Creopop plastic did stick to PLA.)

The Composite Volcano is my favorite -- though it could use a little trimming/cleaning.
Composite volcano, with Creopop highlights
Yes, I suspect my daughter will be 'that' kid. 8-)

Re: Volcanoes

Posted: Mon Feb 29, 2016 10:32 pm
by Jules
Cool! :D