My daughter is a cosmetologist and has more colors of lipstick than I have spools of filament.
She has an 18-cell rack and asked me if I could double that capacity for her.
I pushed the Y axis of the M2 to the limit with barely enough room to fit in a 1-outline brim.
This is eSun PETG. I used the .35 nozzle and .2mm layers. I run slow on solid infills and outline so my build times run long. This was a 42 hour build. Ran it on Kapton over glass. The edges of the print lifted the Kapton film just a little.
Lipstick Rack
- Matt_Sharkey
- Posts: 347
- Joined: Mon Oct 20, 2014 3:10 pm
Re: Lipstick Rack
my fiance just contracted me to make her a lipstick rack, I'll have to compare with your's once I get around to it. Nice work.