More mod podging
Posted: Mon Aug 08, 2016 6:07 pm
Last night I looked around my desk and saw my tub of mod podge, my new inkjet printer, and my new craft cutter, and decided I needed to do something. I decided on a photo back for my 3D printed phone case. I had the model, so I was able to extract the back face as a DXF to cut from. I also have a non-decorative idea for a printed back where I would put several loyalty card bar codes and my Starbucks barcode.
You can see in this one the resulting texture, I might try sanding it down to get it more glossy:
You can see in this one the resulting texture, I might try sanding it down to get it more glossy: