Radiator for toy car.

Show off your prints!!!

Re: Radiator for toy car.

Postby ednisley » Mon May 15, 2017 8:35 pm

Quark wrote:a single pass starting on the inside and ending on the outside

That doesn't sound right: each layer should have a single closed perimeter thread outlining the whole radiator shape. If the fins are smaller than the extrusion width, then the slicer may suffer a brain cramp and do silly things, but … those short thread snippets may also indicate a non-manifold model triggering bizarre slicing results that almost work.

its a little beat up

Hey, it's supposed to look like that! [grin] Nice detailing!
User avatar
Posts: 981
Joined: Fri Apr 11, 2014 5:34 pm
Location: Halfway up the Hudson


Return to Printed Object Showcase

Who is online

Users browsing this forum: No registered users and 4 guests