First print on M3 and using flexible filament (Cheetah)
Posted: Thu Oct 12, 2017 5:44 pm
My first official print on the M3 and using flexible filament (Cheetah) - a drone housing for a GoPro.
I'm very impressed with the M3 ( dual ). I have used an M2 for the last year. Also a great printer.
I added the picture. ragged edges are support that hasn't been pulled off. Support comes off nicely. Was necessary due to small height differences between the top and bottom parts that are connected.
The hood looking thing is the ooze shield - a result of accidentally checking the box in Simplify3D. I don't believe it was necessary.
I'm very impressed with the M3 ( dual ). I have used an M2 for the last year. Also a great printer.
I added the picture. ragged edges are support that hasn't been pulled off. Support comes off nicely. Was necessary due to small height differences between the top and bottom parts that are connected.
The hood looking thing is the ooze shield - a result of accidentally checking the box in Simplify3D. I don't believe it was necessary.