Pin holder for wire tools
Posted: Sat Jul 14, 2018 11:21 pm
I have a some dental picks I use when weeding supports from miniatures and wanted to make my own tools.. So I picked up some 3/64th steal wire lenghts at a hobby shop and made a holder out of PETG that the rubber sleeve off of a paper mate pen would fit for added control.
Wire is cut to length put in a drill press and pushed into the 1mm hole that is 25mm deep while spinning at slow speed. Once it is press into the hand the tool end can be worked. I sliced this with S3D using 3 process to print the area behind the back of the pin at 100% infill but it really would probably be better to do the entire thing at 100%. When slicing I raised it off the bed and use 25% 1mm supports form the bed only, 2 solid layers and 2 dense layers (Simplified 3D )
This model is in the public area at Onshape.com if you should want to alter it to accept a different sized wire
Wire is cut to length put in a drill press and pushed into the 1mm hole that is 25mm deep while spinning at slow speed. Once it is press into the hand the tool end can be worked. I sliced this with S3D using 3 process to print the area behind the back of the pin at 100% infill but it really would probably be better to do the entire thing at 100%. When slicing I raised it off the bed and use 25% 1mm supports form the bed only, 2 solid layers and 2 dense layers (Simplified 3D )
This model is in the public area at Onshape.com if you should want to alter it to accept a different sized wire