Blowing thru Hotends

TheRyanRanch · Post by **TheRyanRanch** » Fri Mar 04, 2016 8:39 am

Jules wrote:50 mm/sec is good. (i print PETG at 53 mm/sec) But do check the filament drive screw tension too, it might be a "dubble-pronged-problem", as we say here in the south. (Be sure to think that with a sloooow drawl.)

Jules, Whatz ah Dubble-Pronged-problem

and BTW that is a awesome hedge hog logo you got going there

Jules · Post by **Jules** » Fri Mar 04, 2016 1:55 pm

TheRyanRanch wrote:
Jules wrote:50 mm/sec is good. (i print PETG at 53 mm/sec) But do check the filament drive screw tension too, it might be a "dubble-pronged-problem", as we say here in the south. (Be sure to think that with a sloooow drawl.)
Jules, Whatz ah Dubble-Pronged-problem and BTW that is a awesome hedge hog logo you got going there

Thats just me being silly....it means there might be two things going on at the same time. (The speed and the Filament Drive screw tension.)

BTW that is a awesome hedge hog logo you got going there

Chuckle, that's a pic i found somewhere online that looks exactly like my pet Hitchcock always did. (Perpetually disgruntled.)

TheRyanRanch · Post by **TheRyanRanch** » Fri Mar 04, 2016 10:22 pm

Jules wrote:
TheRyanRanch wrote:
Jules wrote:50 mm/sec is good. (i print PETG at 53 mm/sec) But do check the filament drive screw tension too, it might be a "dubble-pronged-problem", as we say here in the south. (Be sure to think that with a sloooow drawl.)
Jules, Whatz ah Dubble-Pronged-problem and BTW that is a awesome hedge hog logo you got going there

Thats just me being silly....it means there might be two things going on at the same time. (The speed and the Filament Drive screw tension.)

BTW that is a awesome hedge hog logo you got going there
Chuckle, that's a pic i found somewhere online that looks exactly like my pet Hitchcock always did. (Perpetually disgruntled.)

Trying to click on the "Like" button

Blowing thru Hotends

Re: Blowing thru Hotends

Re: Blowing thru Hotends

Re: Blowing thru Hotends