M2 Rev.E Z-axis Impacts Bed, Starting Height

ryanreedsmith · Post by **ryanreedsmith** » Sun Mar 13, 2016 5:45 am

Reference video link, https://www.youtube.com/watch?v=NNnES6b ... e=youtu.be. I executed the quick start app and performed the start height and leveling procedures successfully the first time. I have been using the printer nominally with the quick start app, Slicer and SD card (slice with Slicer and execute prints with quick start). I flashed the firmware with M2Marlin-11-30-2015. Arduino IDE reported that the upload completed and the M2 reset. I executed the starting height/level procedure with the quick start app and what you see in the linked video occurred. Please help... P.S. The manual I refer to in the video is this one, https://cdn.shopify.com/s/files/1/0030/ ... 9239265064

Post by **rpollack** » Sun Mar 13, 2016 7:03 am

Check your email per your support ticket request. That is not the correct firmware for your machine. Also, please refer to the manual that was included with the printer.

M2 Rev.E Z-axis Impacts Bed, Starting Height

M2 Rev.E Z-axis Impacts Bed, Starting Height

Re: M2 Rev.E Z-axis Impacts Bed, Starting Height