Z axis homes to bottom (Cura with M2 question)

[Jaster]

Hello,

I'm testing an M2 to put in a 3D printing lab. We primarily use Cura as our slicing/operating software. Everything seems to be fine with the machine, however it homes the Z axis to the bottom of the machine rather than the top when using the Cura Pronterface UI. I have NOT attempted a print yet as I was concerned that I may need to invert the Zaxis on the firmware or just be printing in space. Has anyone else had experience using Cura with the M2?

[insta]

Is it only Cura doing this? The slicer can't control which direction the printer homes -- that's a compiled-in firmware option (so not even EEPROM can overwrite it)

[sthone]

S3D homes to the bottom too now with the new setup (bottom end stop) but it still prints fine because the firmware handles all the flipping and offsets.