Requesting guidance with wiring up PT100 board

Ask the MakerGear community for assistance...
Post Reply
User avatar
Farr0wn3d
Posts: 319
Joined: Tue Mar 31, 2015 4:16 am
Location: Calgary, Alberta, Canada

Requesting guidance with wiring up PT100 board

Post by Farr0wn3d » Sun Mar 05, 2017 10:34 pm

I understand that I need to locate a 5v, ground, and analog input pins, and then make some minor firmware tweaks to accept the new sensor.

Can anyone help me out with pin selection? Tech support with ultimachine just gave me the wiki from e3d and thats for a ramps board which I'm having a difficult time relating to the rambo.

Any help would be appreciated !
Top
User avatar
Farr0wn3d
Posts: 319
Joined: Tue Mar 31, 2015 4:16 am
Location: Calgary, Alberta, Canada

Re: Requesting guidance with wiring up PT100 board

Post by Farr0wn3d » Mon Mar 06, 2017 2:09 am

Nevermind, got it up and running.
Top
Post Reply

Return to “Tech Support”