Does M2 Marlin Firmware Support "Stealth Mode"?

Ask the MakerGear community for assistance...
Post Reply
Gwhite
Posts: 293
Joined: Tue Jul 11, 2017 3:38 pm

Does M2 Marlin Firmware Support "Stealth Mode"?

Post by Gwhite » Thu Dec 31, 2020 7:57 pm

I'm setting up a configuration in PrusaSlicer for my M2E. One checkbox is for "Supports Stealth Mode". I'd never heard of this, but I figured I'd ask if the MakerGear firmware supports it. It apparently slows/smooths things down so it's not as noisy.

Thanks!

airscapes
Posts: 483
Joined: Wed Jan 31, 2018 11:36 pm

Re: Does M2 Marlin Firmware Support "Stealth Mode"?

Post by airscapes » Thu Dec 31, 2020 8:11 pm

Not sure about that G, but I have attached a PS project file of a PETG printed model. Made this on PS 2.3 rc2 but I think you can import it and it should all just work. Can you try it for me? The think I don't know is if includes all the data like a factory file. I have printed this model with this config 4 times and all looked better than the 4 I did with S3D as I think I told you the other day in a different thread.
Thanks!
Doug

Can not attached here is the 3mf file
https://misc.airscapesart.com/prusaslic ... leg_V1.3mf

This is the ini file, right click and save or it will just show up as text
https://misc.airscapesart.com/prusaslic ... bundle.ini

Bioluminous
Posts: 11
Joined: Tue Oct 27, 2020 11:03 pm

Re: Does M2 Marlin Firmware Support "Stealth Mode"?

Post by Bioluminous » Thu Dec 31, 2020 8:20 pm

On my Prusa MK3, you select stealth mode on the printer screen. On my M2 screen, I don't see any setting that would be equivalent so I don't think it's part of the firmware. Same with on my M3.

Post Reply