Ask the MakerGear community for assistance...
-
sthone
- Posts: 897
- Joined: Tue Jul 08, 2014 8:25 pm
- Location: Connecticut
-
Contact:
Post
by sthone » Sun Oct 18, 2015 10:31 pm
I guess you did take that the wrong way.
I apologize... it just bothers me when someone comes into someone else's home (this forum) and tries to take a dump (that quoted statement) right on their dining room table.
In the future when in doubt about anything just ask everyone on this forum is always willing to help.
Again sorry no hard feelings...
-Steve
-
MagicEngineer
- Posts: 114
- Joined: Thu Aug 20, 2015 12:39 am
Post
by MagicEngineer » Sun Oct 18, 2015 10:56 pm
sthone wrote:I guess you did take that the wrong way.
I apologize... it just bothers me when someone comes into someone else's home (this forum) and tries to take a dump (that quoted statement) right on their dining room table.
In the future when in doubt about anything just ask everyone on this forum is always willing to help.
Again sorry no hard feelings...
-Steve
No dump was intended, as my response to insta explains. I am very happy with my choice to buy the M2, and while it has been, and still is a steep learning curve, I feel that I can suggest improvements from the perspective of a new user as opposed to that of an experienced one. As someone who thoroughly alpha tests all the software I create only to inevitably have numerous bugs found in beta I can tell you first hand that often the perspective of the new user is far more valuable than my own. I respect your protective instinct toward Makergear and their products so I accept your apology. I do believe, however, I took the statement exactly as you meant it.
