Phantom Y zero-ing
Posted: Sat May 10, 2014 8:38 am
I'm having a bit of an issue with my Y-axis when homing... it'll keep homing to positions well short of the actual zero, which is ending up with prints starting well off centre and going off the back of the bed if i'm not watching.
I checked that the switch functions, and it does. I also check it wasn't being partially pressed by the rail or anything that might be close to triggering it.
Any ideas?
I checked that the switch functions, and it does. I also check it wasn't being partially pressed by the rail or anything that might be close to triggering it.
Any ideas?