Page 1 of 1
clumps when printing
Posted: Tue Feb 10, 2015 3:35 am
by robkiller
So I have the maker gear m2 and I have not printed for a while. I just started to print again and my filament is not coming out in a smooth line its dropping clumps . Any ideas? I am using pla at 210 bed at 60. It comes out and raps on the nozzle and will deposits clumps alone the path it takes.
Re: clumps when printing
Posted: Tue Feb 10, 2015 3:41 am
by robkiller
A picture to help you understand what I am seeing.
Re: clumps when printing
Posted: Tue Feb 10, 2015 3:43 am
by insta
How's your first layer height?
Re: clumps when printing
Posted: Tue Feb 10, 2015 3:49 am
by robkiller
settings
- print2.png (21.51 KiB) Viewed 9654 times
Re: clumps when printing
Posted: Tue Feb 10, 2015 3:53 am
by insta
Can you take a picture of the first layer as its printing, with how far the nozzle is off the bed?
Re: clumps when printing
Posted: Tue Feb 10, 2015 4:00 am
by robkiller
I will try the way I set it up is I fold a paper over in two and adjust it so the paper has friction when I pull it out from between the nozzle and the bed.
Any better suggestions? I will try to take a video but I don't know how easy that will be so you can see the gap.
Re: clumps when printing
Posted: Wed Feb 11, 2015 3:37 am
by robkiller
I am going to start a new thread on my findings and added problems. I don't think the title fits the thread anymore after my next post.
New thread
viewtopic.php?f=7&t=1916