Sainsmart LCD screen

Ask the MakerGear community for assistance...
Post Reply
tommy
Posts: 18
Joined: Mon Apr 14, 2014 3:36 am

Sainsmart LCD screen

Post by tommy » Fri May 16, 2014 11:11 pm

Hey guys, I got this a while ago http://www.amazon.com/SainSmart-Control ... 3d+printer and I'm wondering if any of you guys know how I could wire it into the rambo board. Thanks.
It's an M2.

jsc
Posts: 1864
Joined: Thu Apr 10, 2014 4:00 am

Re: Sainsmart LCD screen

Post by jsc » Sat May 17, 2014 12:25 am

Oh man. You're going to have to figure out how to configure the firmware for it, then wire it into the RAMBo.

Your best bet is to find somebody who has got it to work with RAMBo rather than RAMPS, and crib off their work.

It is probably technically feasible, but I haven't heard of anyone using a non-Viki panel on an M2 yet, so you are probably breaking new ground.

tommy
Posts: 18
Joined: Mon Apr 14, 2014 3:36 am

Re: Sainsmart LCD screen

Post by tommy » Thu May 22, 2014 1:36 pm

Thanks so much for answering me. But I'm not the man to figure that out. I'll just keep searching online probably. Thanks.

Post Reply