Page 1 of 1

Sainsmart LCD screen

Posted: Fri May 16, 2014 11:11 pm
by tommy
Hey guys, I got this a while ago ... 3d+printer and I'm wondering if any of you guys know how I could wire it into the rambo board. Thanks.
It's an M2.

Re: Sainsmart LCD screen

Posted: Sat May 17, 2014 12:25 am
by jsc
Oh man. You're going to have to figure out how to configure the firmware for it, then wire it into the RAMBo.

Your best bet is to find somebody who has got it to work with RAMBo rather than RAMPS, and crib off their work.

It is probably technically feasible, but I haven't heard of anyone using a non-Viki panel on an M2 yet, so you are probably breaking new ground.

Re: Sainsmart LCD screen

Posted: Thu May 22, 2014 1:36 pm
by tommy
Thanks so much for answering me. But I'm not the man to figure that out. I'll just keep searching online probably. Thanks.