Wiring harness identification

Ask the MakerGear community for assistance...
Post Reply
Posts: 19
Joined: Wed May 07, 2014 9:29 pm

Wiring harness identification

Post by HadMatter » Tue May 20, 2014 1:49 pm


Ok silly question but i'm stumped. The male and female, 2-wire connectors you guys use for the fan wiring etc.
What are those called exactly? Also, can I re-terminate them to the wires is there is a break? If so, How?
and where could I order a bulk quantity if these?



Posts: 1864
Joined: Thu Apr 10, 2014 4:00 am

Re: Wiring harness identification

Post by jsc » Tue May 20, 2014 5:04 pm

You can get them from MakerGear.

If the break happened not too close to the old one, you can just solder the wires together. One of the fans I bought came with some pigtail crimp connectors that you might use, they look like this, but I think I prefer soldering in the future.

Post Reply