MakerGear Forum

Posted: **Thu Nov 05, 2015 12:25 am**

My Z Endstop broke. The files on GitHub are different that what came on my 24v model. The hole for the LED is smaller and they have the nuts on the clamp instead of on the body, which makes it impossible to tighten properly since the bolt heads point towards the chassis.

Anyone know if there's a newer STL for these, or maybe they are somewhere else on GitHub other than the page the support site points to?

I already wrote Makergear tonight, but hoping someone may have the answer so I can print them tonight.

Posted: **Thu Nov 05, 2015 12:57 am**

yeah i have a couple. the original one and the new one for the v4. i would suggest you use the newer one. its much better.

Z Endstop Bracket - Compact.STL: (963.56 KiB) Downloaded 564 times

M2+Z+Endstop+Body.stl: (59.46 KiB) Downloaded 552 times

M2+Z+Endstop+Clamp.stl: (21.96 KiB) Downloaded 529 times

Posted: **Thu Nov 05, 2015 1:38 am**

Great! Thanks Jim!

MakerGear Forum

Newer Z Endstop STL's?

Newer Z Endstop STL's?

Re: Newer Z Endstop STL's?

Re: Newer Z Endstop STL's?