problem in printing

Ask the MakerGear community for assistance...
sonra
Posts: 116
Joined: Sat Aug 22, 2015 3:44 pm
Location: Israel

Re: problem in printing

Post by sonra » Mon Nov 30, 2015 8:08 pm

I did use any other material then PLA the screw are OK . I try to print with a new PLA roll that I take out from pack and has a anti humidity material little beg in and get the some result as you can see in picture some of print is nice and some is like points
Attachments
20151130_203834.jpg

User avatar
Jules
Posts: 3144
Joined: Wed Jan 21, 2015 1:36 am

Re: problem in printing

Post by Jules » Mon Nov 30, 2015 8:15 pm

That looks like a really low spot in the bed, with a serious over-extrusion situation. (Air printing on one side - might be a level problem.)
Did you change the plate for a different one?

Is your bed still level?

viewtopic.php?f=3&t=2783

Have you checked the gap lately (to see if it is still small enough) by running the calibration for height?

viewtopic.php?f=3&t=3124

sonra
Posts: 116
Joined: Sat Aug 22, 2015 3:44 pm
Location: Israel

Re: problem in printing

Post by sonra » Tue Dec 01, 2015 5:40 pm

Hi guys
It was a problem of leveling ans Z endstop .Thanks for help

Post Reply