Page 2 of 2
Re: problem in printing
Posted: Mon Nov 30, 2015 8:08 pm
by sonra
I did use any other material then PLA the screw are OK . I try to print with a new PLA roll that I take out from pack and has a anti humidity material little beg in and get the some result as you can see in picture some of print is nice and some is like points
Re: problem in printing
Posted: Mon Nov 30, 2015 8:15 pm
by Jules
That looks like a really low spot in the bed, with a serious over-extrusion situation. (Air printing on one side - might be a level problem.)
Did you change the plate for a different one?
Is your bed still level?
viewtopic.php?f=3&t=2783
Have you checked the gap lately (to see if it is still small enough) by running the calibration for height?
viewtopic.php?f=3&t=3124
Re: problem in printing
Posted: Tue Dec 01, 2015 5:40 pm
by sonra
Hi guys
It was a problem of leveling ans Z endstop .Thanks for help