Snapped Hot End

Ask the MakerGear community for assistance...
Mach
Posts: 63
Joined: Sun Nov 29, 2015 1:05 am

Re: Snapped Hot End

Post by Mach » Wed Dec 23, 2015 2:59 pm

insta wrote:Can the new barrel be seated just by tightening the nozzle down?
Ditto, just screw on the nozzle and it seats.

sonra
Posts: 110
Joined: Sat Aug 22, 2015 3:44 pm
Location: Israel

Re: Snapped Hot End

Post by sonra » Thu May 21, 2020 11:59 am

Hi
I have the some problem and to remove the broken barrel I use some masking type to connect it to open socket and use an hammer to hit on the barrel and it HELP to remove the barrel ( this if you don't have clamps )
Doron

Post Reply