M2 Digital Controller Question

legend85 · Post by **legend85** » Tue Dec 08, 2015 4:37 pm

We are taking one of our M2s to a recruiting event this week, and are using it as a standalone with the new digital controller. We cannot figure out how to load and unload filament. This was shown to me at one point, but I cannot remember.

Also, is there a guide available somewhere for these controllers?

Thank you.

insta · Post by **insta** » Thu Dec 10, 2015 5:15 pm

Is this the Geeetech LCD or Viki1 you're using?

legend85 · Post by **legend85** » Sat Dec 12, 2015 7:25 am

Thanks for the reply - I will look on Monday when we return to school. These machines were among the first released with the digital controllers. We took delivery of them in Oct.

PcS · Post by **PcS** » Sun Dec 13, 2015 7:01 pm

Geetech I'm guessing . It is under control or movement I think , then axis then amount.

M2 Digital Controller Question

M2 Digital Controller Question

Re: M2 Digital Controller Question

Re: M2 Digital Controller Question

Re: M2 Digital Controller Question