MakerGear Forum

We are taking one of our M2s to a recruiting event this week, and are using it as a standalone with the new digital controller. We cannot figure out how to load and unload filament. This was shown to me at one point, but I cannot remember.

Also, is there a guide available somewhere for these controllers?

Thank you.

Is this the Geeetech LCD or Viki1 you're using?

Thanks for the reply - I will look on Monday when we return to school. These machines were among the first released with the digital controllers. We took delivery of them in Oct.

Geetech I'm guessing . It is under control or movement I think , then axis then amount.