Lubrication - Request for more info
Posted: Thu May 29, 2014 7:32 pm
My pre-assembled M2 came with a short blurb about using 3-in-1 on the linear shafting and lithium grease on the linear rails.
Looking at the parts pdf, I see what the linear rails are (x and y). And I assume the linear shafting are the two rods on either side of the z-axis jack screw - so 3-in-1 oil for them.
What I don't have is information on the lube for the long z-axis jack screw. Does anyone have an idea for best practices for lube on these parts?
What lube goes on the jackscrew"? If any...
My document says every 90 days or every 30 days. What are you experienced guys doing?
MakerGear sent a small tub of grease - does anyone have a source for white lithium grease?
Looking at the parts pdf, I see what the linear rails are (x and y). And I assume the linear shafting are the two rods on either side of the z-axis jack screw - so 3-in-1 oil for them.
What I don't have is information on the lube for the long z-axis jack screw. Does anyone have an idea for best practices for lube on these parts?
What lube goes on the jackscrew"? If any...
My document says every 90 days or every 30 days. What are you experienced guys doing?
MakerGear sent a small tub of grease - does anyone have a source for white lithium grease?