Extruder mount failed
Re: Extruder mount failed
Check out Smooth-On XTC3D or similar thin epoxy for a similar effect. There's a few threads on it around here somewhere. I played around with vapor smoothing in my early days, but it was difficult to get a consistent result top to bottom.
Re: Extruder mount failed
This may remain an "unsolved mystery". But the obvious solution is to get the metal motor mount. . .
Re: Extruder mount failed
I've looked at XTC3d. It works well. Acetone is a little faster and cheaper. I'm having decent results with my paint can system. I'll post it up when I get pics.
I've got the metal motor mount but was waiting for some printer down time to install it and the dampers. Ask and ye shall receive.
I've got the metal motor mount but was waiting for some printer down time to install it and the dampers. Ask and ye shall receive.