Extruder Stepper Motor Molex Connector
Posted: Sat Apr 30, 2016 2:09 pm
Does anybody know where to get the female Molex connector going from board to Extruder Stepper Motor?
Thank you,
Naz
Thank you,
Naz
You can get all the connectors you need from Digi-Key (http://www.digikey.com).nazekaosman wrote:Does anybody know where to get the female Molex connector going from board to Extruder Stepper Motor?
On the stepper motor side, the connector is similar to a Molex but the type used is made by JST:
JST-PH Series, specifically the JST-PH6 (JST style, PH Series, 6 positions), Digikey part# 455-1162-ND.
On the board side, the connector is a Molex, Digikey part# WM5364-ND. I had an old RAMBo when I traded it in for a Smoothie, but I think they still use a plain 4-pin socked that does not have a keyed header, specifically so that the plug can be put in either way.