Printing replacement parts in nylon?

Ask the MakerGear community for assistance...
Post Reply
Mach
Posts: 63
Joined: Sun Nov 29, 2015 1:05 am

Printing replacement parts in nylon?

Post by Mach » Mon May 02, 2016 5:04 pm

Any reason not to use Nylon or its variant so print M2 replacement parts? I've got a couple of spools of Taulman Bridge http://taulman3d.com/bridge-features.html. Its a hybrid nylon. Shrinkage is the only concern that I can see that would be problematic.

Post Reply