I went in a cleaned and oiled everything, lithium grease on the z-screw. Had a minor heart attack when none of the motors worked, until discovered that the main power connector in back had come a little lose when I turned the printer to work on it. Everything seems to be working again. I am trying another print, fingers crossed. Thank you all for you support and suggestions.
BTW. I am using my new GeckoTek build plates. No tape, glue, spray required. They just WORK. Great product. Can't recommend them enough.
Z motor problems HELP
- Matt_Sharkey
- Posts: 347
- Joined: Mon Oct 20, 2014 3:10 pm
Re: Z motor problems HELP
Not sure if there was actually a problem...
Or just here to advertise for GeckoTek....
Or just here to advertise for GeckoTek....