MakerGear Forum

Posted: **Wed May 25, 2016 12:13 pm**

Currently working on a functional piece for a client, and the build plate face needs to be as smooth as possible. I seem to keep getting this effect on the first layer. Extrusion width is spot on, and vertical/horizontal beads just bairly touch on the first layer, so I'm assuming it's not an issue with extrusion or z-height? I'm stumped.

Thanks!

Hatchbox PLA White.fff: (11.11 KiB) Downloaded 418 times

Posted: **Wed May 25, 2016 12:38 pm**

Your bed gap is just slightly too tight

Posted: **Thu May 26, 2016 3:50 am**

jimc wrote:Your bed gap is just slightly too tight

Changed the Global Z Offset to .02 and that did the trick! Thanks Jim!

MakerGear Forum

Wrinkling/Waving/Rippling on large print bottom layer

Wrinkling/Waving/Rippling on large print bottom layer

Re: Wrinkling/Waving/Rippling on large print bottom layer

Re: Wrinkling/Waving/Rippling on large print bottom layer