Print stops (incomplete) after 20+ hrs...need help

[scampa123]

90 what? C or F?

Fahrenheit

[jimc]

90f is not hot at all for the electronics. that should not be causing issues at those temps. if it was 120 then thats another story

[scampa123]

90f is not hot at all for the electronics. that should not be causing issues at those temps. if it was 120 then thats another story

But it sure seems like that is the case...

[scampa123]

I still think this was heat related. I've been printing with the doors open and the print jobs haven't stopped...

So the only other thought may be is the M2 actually heating to what it thinks it is heating to? Could a sensor have gone bad?

Else it means I have an enclose for nothing!

[jimc]

move the electronics box outside the enclosure

[scampa123]

Good idea!!