Can't get Z End Stop Correct

Ask the MakerGear community for assistance...
Post Reply
derekcfi
Posts: 20
Joined: Wed Jun 29, 2016 7:33 pm

Re: Can't get Z End Stop Correct

Post by derekcfi » Sat Jul 09, 2016 8:34 pm

OK, I will re-apply the glue.

Here is what I got on this cal I just did:

2.02
2.02
2.03
2.01
Top
User avatar
Jules
Posts: 3144
Joined: Wed Jan 21, 2015 1:36 am

Re: Can't get Z End Stop Correct

Post by Jules » Sat Jul 09, 2016 9:11 pm

Here is what I got on this cal I just did:

2.02
2.02
2.03
2.01
That is fine....most calipers cannot measure any closer than that. Your Z-Stop and Z-Offset are set correctly. Add some glue and go print something. :)
Top
derekcfi
Posts: 20
Joined: Wed Jun 29, 2016 7:33 pm

Re: Can't get Z End Stop Correct

Post by derekcfi » Mon Jul 11, 2016 4:08 pm

ITS WORKING!!!!!!!!!!!!!!!!!!!!!!!!!
Top
User avatar
Jules
Posts: 3144
Joined: Wed Jan 21, 2015 1:36 am

Re: Can't get Z End Stop Correct

Post by Jules » Mon Jul 11, 2016 4:30 pm

Hallelujah! :lol:
Top
Post Reply

Return to “Tech Support”