Can't get Z End Stop Correct
Posted: Wed Jun 29, 2016 9:10 pm
Greetings,
I've set my Z End Stop and leveled my bed about 50 times in the past two days. I have used every different method described on this forum (getting started,etc), on youtube, and the methods used by MakerGear. None of them are working. The filament just curls around the hot end and nothing attaches to the bed. I'm starting to get really frustrated.
Using:
M2 v3b
Simplify 3d
1.75mm PLA
215/70c temps on glass bed
I set Z-Stop ranges from 1 sheet of paper(unfolded) all the way up to and including .2mm using a feeler gauge. Everything was heated up. I tried it manually and using z-home to hold the bed up.
I do not know what I am doing wrong. I have read and re-read every beginner thread on this forum.
Please help!
I've set my Z End Stop and leveled my bed about 50 times in the past two days. I have used every different method described on this forum (getting started,etc), on youtube, and the methods used by MakerGear. None of them are working. The filament just curls around the hot end and nothing attaches to the bed. I'm starting to get really frustrated.
Using:
M2 v3b
Simplify 3d
1.75mm PLA
215/70c temps on glass bed
I set Z-Stop ranges from 1 sheet of paper(unfolded) all the way up to and including .2mm using a feeler gauge. Everything was heated up. I tried it manually and using z-home to hold the bed up.
I do not know what I am doing wrong. I have read and re-read every beginner thread on this forum.
Please help!