Electronics / Hotend Fan not running after dual upgrade
Posted: Sun Aug 07, 2016 4:07 am
Hi All,
Just got through the dual extruder upgrade on my Rev.E machine, and now the board fan and extruder fan (NOT the bed fan) are running for about two seconds after power-on, and then they shut right off.
Not sure what to do?
Thanks
edit- I may be stupid again - does the filament fan run all the time or only when the extruders are on?
Just got through the dual extruder upgrade on my Rev.E machine, and now the board fan and extruder fan (NOT the bed fan) are running for about two seconds after power-on, and then they shut right off.
Not sure what to do?
Thanks
edit- I may be stupid again - does the filament fan run all the time or only when the extruders are on?