SD Card Cable Orientation

Ask the MakerGear community for assistance...
Post Reply
sonra
Posts: 86
Joined: Sat Aug 22, 2015 3:44 pm
Location: Israel

SD Card Cable Orientation

Post by sonra » Wed Sep 07, 2016 2:35 pm

Hi
I by mistake disconnect the cable from board . I have a cable with 6 color wires . try to find in manuals the right way to plug the cable .
it will be nice to have how to connect on the other side to the reader connector
Regards Doron

User avatar
sthone
Posts: 890
Joined: Tue Jul 08, 2014 8:25 pm
Location: Connecticut
Contact:

Re: SD Card Cable Orientation

Post by sthone » Wed Sep 07, 2016 3:41 pm

Which end did you unplug the end going to the Rambo or the end going to the actual card reader?

If it's the end going to the card reader (attached to the lid)... Looking from the front the Red wire goes on the left side. (Keep in mine this is on the old plastic electronic boxes, I'm not sure if it changed on the metal enclosure. )

Edit-Since they changed the website I can''t find the old Kit instructions anymore. :cry: but..... You can just see the connector at the top of this picture.

Image
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com

sonra
Posts: 86
Joined: Sat Aug 22, 2015 3:44 pm
Location: Israel

Re: SD Card Cable Orientation

Post by sonra » Fri Sep 09, 2016 2:47 pm

thanks
It is on the other side (the Rambo side ) . I think I have a problem with the interface board . I tried to connect it in the 2 posibble ways . With no success in getting the reader to work. Does any has the electronic scheme of this board ??

User avatar
sthone
Posts: 890
Joined: Tue Jul 08, 2014 8:25 pm
Location: Connecticut
Contact:

Re: SD Card Cable Orientation

Post by sthone » Fri Sep 09, 2016 2:57 pm

http://reprap.org/wiki/Rambo_v1.3 (I think that's the right version :? )
____________________________________________________
See my projects at https://www.theneverendingprojectslist.com

sonra
Posts: 86
Joined: Sat Aug 22, 2015 3:44 pm
Location: Israel

Re: SD Card Cable Orientation

Post by sonra » Fri Sep 09, 2016 3:51 pm

Thanks .I meant the sd card interface board and not the Rambo

User avatar
willnewton
Posts: 477
Joined: Wed Apr 09, 2014 8:32 pm

Re: SD Card Cable Orientation

Post by willnewton » Sun Sep 11, 2016 12:45 am

I'm finally back to where I started two days ago!

A thread with some stuff in it I update every once in a while. viewtopic.php?f=8&t=9
See some of my stuff http://www.thingiverse.com/willnewton/about

Post Reply