Not getting smooth top in calibration square
Not getting smooth top in calibration square
I've been recalibrating and I did the cube without the top. Z bottom and got it to .40mm...but when doing the solid square I'm not getting a smooth top taker...Any thoughts?
Thx!
Thx!
Re: Not getting smooth top in calibration square
My settings:
PETG
Filament Dia 1.87
Ext Multi: .70
Extr Width Manual: .40
PETG
Filament Dia 1.87
Ext Multi: .70
Extr Width Manual: .40
Re: Not getting smooth top in calibration square
Number of top layers?
Infill?
Infill?
Re: Not getting smooth top in calibration square
Top Solid Layers 3
Infill 100%
Infill 100%
Re: Not getting smooth top in calibration square
That's at 100% infill? (Serious underextrusion problem.)
Re: Not getting smooth top in calibration square
What should I do to up the extrusion? I had calibrated with the square without the infill to .40mm
-
- Posts: 277
- Joined: Fri Oct 02, 2015 5:37 am
Re: Not getting smooth top in calibration square
Most Filament is 1.75mm, so 1.87 does not make sense, unless it is way out of spec.
With that said, the extrusion multiplier should be about .86 - .89. Your's is too low.
With that said, the extrusion multiplier should be about .86 - .89. Your's is too low.
M2 - V4, MIC-6 Build Plate, Astrosyn Damper's(X/Y), Rev. E, Geeetech LCD
S3D - FFF Settings https://forum.simplify3d.com/viewtopic.php?f=8&t=2367
Print Quality Troubleshooting https://www.simplify3d.com/support/prin ... eshooting/
S3D - FFF Settings https://forum.simplify3d.com/viewtopic.php?f=8&t=2367
Print Quality Troubleshooting https://www.simplify3d.com/support/prin ... eshooting/
Re: Not getting smooth top in calibration square
Yeah....try 1.75 mm diameter and 0.90 for the extrusion multiplier. (You might find it doesn't impact the wall thickness much.)
Re: Not getting smooth top in calibration square
That seemed to work much better!! Thank you!!!
Re: Not getting smooth top in calibration square
So that worked for the overall calibration square but I noticed something odd...
I'm basically printing a rectangle, a base for a circuit board, and what I am getting on the initial outlines are dots vs a smooth line...hopefully the picture helps:
I'm basically printing a rectangle, a base for a circuit board, and what I am getting on the initial outlines are dots vs a smooth line...hopefully the picture helps: