MakerGear Forum

I received a lcd panel with my kit and no instructions for that, in the package (that I saw anyway)

I dont see it online either?

Anyone know of a picture of how this goes into the board? (I am assuming its just that simple and the current sd reader comes out?

Mine came with the ribbon cables already attached to the Rambo board. I just had to plug in the cables to the display itself but it was clearly marked:
Did you check the wiki page already? http://makergear.wikidot.com/m2-lcd-panel

my connectors do not look like that, but the wiki seems what I needed

Sorry I was looking on the maker gear site itself