Requesting guidance with wiring up PT100 board
Posted: Sun Mar 05, 2017 10:34 pm
I understand that I need to locate a 5v, ground, and analog input pins, and then make some minor firmware tweaks to accept the new sensor.
Can anyone help me out with pin selection? Tech support with ultimachine just gave me the wiki from e3d and thats for a ramps board which I'm having a difficult time relating to the rambo.
Any help would be appreciated !
Can anyone help me out with pin selection? Tech support with ultimachine just gave me the wiki from e3d and thats for a ramps board which I'm having a difficult time relating to the rambo.
Any help would be appreciated !