PETG Filament Drive S3D Settings
Posted: Sun Mar 26, 2017 4:33 pm
Hello,
I am working on printing a filament drive with eSun PETG in black using S3D. I am wondering what the suggested settings for the drive are for infill, top, bottom, and outline layer count are. Is 3 top and bottom, 2 outline ok? I am using Jules PETG setting per her instruction thread.
I am not sure it needs 100% infill, maybe 65-75%. I am generating support but only using them for the 90 degree areas where there is considerable bridging.
Thank you,
Jerold
I am working on printing a filament drive with eSun PETG in black using S3D. I am wondering what the suggested settings for the drive are for infill, top, bottom, and outline layer count are. Is 3 top and bottom, 2 outline ok? I am using Jules PETG setting per her instruction thread.
I am not sure it needs 100% infill, maybe 65-75%. I am generating support but only using them for the 90 degree areas where there is considerable bridging.
Thank you,
Jerold