MakerGear Forum

I am making some coasters using an SVG to emboss a logo into top. I designed the coaster with a smaller 2mm cylinder at the start of the emboss. This gives the embossed logo a different color inside.

I am finding that I I have to chose the extruder that is used to infill. Is there anyway to infill will both nozzles so the colors don't mix up?

Thanks,
Jerold

Probably a way to do it by setting up separate Processes in the S3D program....but that is not something I've tried to do. Check the S3D forum for videos on how to set it up.