Hey guys.
So I purchased a used machine and I was testing it out today. Everything is great so far, but there's a small problem. My filament drive is too far to the right over the extruder! No idea how to handle this. Can't find anything in the manual. Is there a screw to loosen to move it back? Here's a picture of what I'm talking about. Thanks.
Spencer
Filament Guide too far right above extruder
Re: Filament Guide too far right above extruder
If you loosen the mounting screws you should be able to rotate it so it aligns with the hole.
Re: Filament Guide too far right above extruder
After a while of tinkering, it seem to work itself out weirdly.. Thanks for your help!