problem with new filament drive and groovemount

Ask the MakerGear community for assistance...
Post Reply
sonra
Posts: 116
Joined: Sat Aug 22, 2015 3:44 pm
Location: Israel

problem with new filament drive and groovemount

Post by sonra » Wed Jul 05, 2017 6:20 pm

Hi guys
I have a m2 v3b printer and after many times i had to clean a clogged hotend the filament drive get broken in the area that hold the hotend so I ordered new drive and groovemount , but now when i connects them the filament does not enter to the groovmount ( for some reason the holes of both are not aligned ) did any one had a problem like that ?
Regards Doron

Post Reply