Calibration Screw loosening during long prints
Posted: Wed Jul 12, 2017 2:45 pm
Hello!
I'm having a problem for the last 2-3 weeks.
It seems that one of the Calibration Screw (I have the table with 3 screws) is lossening after a few hours of continued printing.
In my case, the only one doing that is the right adjustment screw, according to the image below.
Once, it even lossed completely, falling to the ground... When I reached the printed, the table (so the print, too) was completely unaligned.
I've checked if all the components were in place (spring, plastic ring and screw) and everything is fine... the three adjustment screws are the same way...
Any idea about why this is happening and a possible solution?
Than you very much in advance!
Best regards!
I'm having a problem for the last 2-3 weeks.
It seems that one of the Calibration Screw (I have the table with 3 screws) is lossening after a few hours of continued printing.
In my case, the only one doing that is the right adjustment screw, according to the image below.
Once, it even lossed completely, falling to the ground... When I reached the printed, the table (so the print, too) was completely unaligned.
I've checked if all the components were in place (spring, plastic ring and screw) and everything is fine... the three adjustment screws are the same way...
Any idea about why this is happening and a possible solution?
Than you very much in advance!
Best regards!